micro rc helicopter????

Alvin J

when i turn mine on
and i try to fly it

it justt turns 360 on the table without even going in the air and i tried trimming it like this and the buttons to trim but still...
plz help me any1 .
and also when its charge you charge the green light on the transmitter should turn off
but mine stays on and whn i remove the charger and try to fly it the red light flashes and the green light is still there
this is the exact heli i have
http://site.xheli.com/rc-helicopter1/rc-helicopter7.jpg
plz help me

Answer
I have had alot of experience with mini copters. I can say that 99% of the time the spinning issue is caused by several factors.

1. hair(s) just one hair wrapped around the tail rotor can cause it not to fly correctly. Check for hairs and strings , threads , etc.

2. the trim issue takes ALOT of time. It is digital so it needs several seconds to actually register into the processor bs so it can fine tune itself and set itself. Do this very , very slowly. It will take at least 5-10 minutes.

3. The battery connector harness is so tiny that if it is not plugged in snuggly and all the way in, it will cause it not to charge correctly. Try to verify it is snug by wiggling the harness a little. If it is too tight then it is not set correctly. If it is too loose then it needs to be pushed in harder.

While these are some common remedies there are others too.

Feel free too review my other questions I answered for some more info on micro R/C copters.

Feel free to email me for more specifics too.

What is the best RC Helicopter?

sarah s

I'm looking to buy my 22 year old gamer brother a remote control helicopter, between £20-£30 he likes the shiny black sleek look and also insects and stuff, i dont know where to look and i dont know much about them ! thanks! any help would be massively appreciated.

Answer
Syma S012 Apache AH-64 Mini 3-Channel Infrared RC Helicopter ---NEW!
No Assembly required, Ready To Fly!Flight Stabilizing System with adjustable trimming control.
Real Helicopter Performance with Stable Hover. Full 3 Channels : Up, Down, Left, Right, Forward and Backward.
An incorporated auto stability system making it easy to fly.
A pre-installed 3 channel proportional wide beam infrared control system that is also tri-band A, B, C.
Recharging takes place via the transmitter. The transmitter has an Alignment Trim, a Charging and Power Indicator, a Left/Right Lever and a Trimmer.
http://www.amazon.com/Apache-3-Channel-Infrared-RC-Helicopter/dp/B001O271YG/?tag=partptl-20
.............

Powered by Yahoo! Answers

micro rc helicopter????

Alvin J

when i turn mine on
and i try to fly it

it justt turns 360 on the table without even going in the air and i tried trimming it like this and the buttons to trim but still...
plz help me any1 .
and also when its charge you charge the green light on the transmitter should turn off
but mine stays on and whn i remove the charger and try to fly it the red light flashes and the green light is still there
this is the exact heli i have
http://site.xheli.com/rc-helicopter1/rc-helicopter7.jpg
plz help me

Answer
I have had alot of experience with mini copters. I can say that 99% of the time the spinning issue is caused by several factors.

1. hair(s) just one hair wrapped around the tail rotor can cause it not to fly correctly. Check for hairs and strings , threads , etc.

2. the trim issue takes ALOT of time. It is digital so it needs several seconds to actually register into the processor bs so it can fine tune itself and set itself. Do this very , very slowly. It will take at least 5-10 minutes.

3. The battery connector harness is so tiny that if it is not plugged in snuggly and all the way in, it will cause it not to charge correctly. Try to verify it is snug by wiggling the harness a little. If it is too tight then it is not set correctly. If it is too loose then it needs to be pushed in harder.

While these are some common remedies there are others too.

Feel free too review my other questions I answered for some more info on micro R/C copters.

Feel free to email me for more specifics too.

What is the best RC Helicopter?

sarah s

I'm looking to buy my 22 year old gamer brother a remote control helicopter, between £20-£30 he likes the shiny black sleek look and also insects and stuff, i dont know where to look and i dont know much about them ! thanks! any help would be massively appreciated.

Answer
Syma S012 Apache AH-64 Mini 3-Channel Infrared RC Helicopter ---NEW!
No Assembly required, Ready To Fly!Flight Stabilizing System with adjustable trimming control.
Real Helicopter Performance with Stable Hover. Full 3 Channels : Up, Down, Left, Right, Forward and Backward.
An incorporated auto stability system making it easy to fly.
A pre-installed 3 channel proportional wide beam infrared control system that is also tri-band A, B, C.
Recharging takes place via the transmitter. The transmitter has an Alignment Trim, a Charging and Power Indicator, a Left/Right Lever and a Trimmer.
http://www.amazon.com/Apache-3-Channel-Infrared-RC-Helicopter/dp/B001O271YG/?tag=partptl-20
.............

Powered by Yahoo! Answers

How do i fix a spinning rc helicopter?

Q. The model is ... Cobra 3 channel mini helicopter X107 with gyro. I know that the top blades are spinning faster causeing the issue. But how do i fix it?

Answer
the top blade always spins faster than the bottom one (same with big lama 4ch co-axial helicopter, had one... and always broke the upper blade) so here's what you'll do:

if the helicopter spins in a crazy way to watever side, then:

go to the receiver, next to it there is a mixer, like 2 knobs that you can put a screw on it and move it, look carefully and move the "Proportion" knob left or right until the helicopter stops spinning.

if it spins slowly then:

look your transmitter, it has like little knobs that you can adjust left or right, they're called "Trim tabs" move the trim tab from your rudder left or right until the helicopter is steady.

if that's not the problem then it might be time to replace the motor of the upper blade.

if that's not the problem, go to www.rcgroups.com create an accout, post this question there and folks with waaay more experience than me will help you out.

Happy New Year!

RC Helicopter Help!?

krautpiero

I recently got a RC Helicopter, Bladecx made by E-flight. I watched th video, read the manual, but i still cant figure out why my helocopter always tilts forwards or bac, or left or right. Can someone help me?

Answer
I too have a Blade CX, and I had no idea these things were so hard to fly (without crashing). If there are any nicks in the blades, a slightly bent balance bar or main shaft, or even the battery slightly out of position it will throw the flying characteristics off. There is a procedure for balancing the motors, where you adjust potentiometers on the 3 n 1 unit to get the trims closer to perfect, and it is in the instructions. Don't give up, helicopters are just plain more difficult to fly. Just try to be light and smooth on the sticks and take your time. I raced RC cars, trucks, truggies, minis, etc and the Blade CX was still an entirely new experience for me, and I'm still not an adept pilot, but I am getting better, and so will you.

Powered by Yahoo! Answers

RC mini helicopter trimming?

mini rc helicopter trim image

ImAguy

I got a mini rc helicopter today, not sure of the brand. I think it is called a super battleplane item number 8817. and the trimming doesn't seem to work. I can not get to to fly streight. Any ideas/ suggestions?

Answer
I bought two of those Super Battleplane no. 8817 helicopters, and one of them has the same problem you describe. The other one does not do anything. It appeared to charge up properly, but does not respond whatsoever - after trying all possible switch settings - no action at all. So the day after Christmas, I returned to the mall where it was purchased, and of course, the vendor is gone. Fly by night. There is no warranty on the product so I guess I have no recourse. Chalk it up to experience. Caveat emptor. I'll keep trying the trim and tail adjustments on the one copter that's not DOA.

My Mini rc helicopter was working fine until now, now when i fly it, it turns to the left and spins......?

TCB1468

so i tried adjusting the trim to the right but it has no display of where it is adjusted to it just has 2 buttons (left and right).The trim really hasnt made a difference either. please help

Answer
It's a good idea to use trim and co-ordinate your turns, and in general this should solve the problem. If, however, the problem persists, then I would guess that you would'veve thrown the tail rotor assembly out of whack. This may be the angle of the blades being improperly balanced, or a faulty motor, or something else. I would recommend that you take it to your nearest hobby shop to have it checked out. Above all, though, remember that a helo is not particularly stable and to fly it properly may be as simple as taking a few hours of time aside for some good, old-fashioned practice. Try and make your movements small, but direct and very, very precise. It's a skill that has to be honed very accurately.

Powered by Yahoo! Answers

i have a 735 set 3h mini Rc helicopter i adjust the trimmer it stops spinnin but then spins the other way Help?

mini rc helicopter trim image

TJ

.

Answer
before you take off from the ground, try hand launching it at head level. Once it is leveled in mid air, then trim it. If nothing, you bought a cheap poorly engineered helicopter. Sorry, but people made cheap helicopters and have been scamming people since the first micro helicopter was made.

RC mini helicopter trimming?

ImAguy

I got a mini rc helicopter today, not sure of the brand. I think it is called a super battleplane item number 8817. and the trimming doesn't seem to work. I can not get to to fly streight. Any ideas/ suggestions?

Answer
I bought two of those Super Battleplane no. 8817 helicopters, and one of them has the same problem you describe. The other one does not do anything. It appeared to charge up properly, but does not respond whatsoever - after trying all possible switch settings - no action at all. So the day after Christmas, I returned to the mall where it was purchased, and of course, the vendor is gone. Fly by night. There is no warranty on the product so I guess I have no recourse. Chalk it up to experience. Caveat emptor. I'll keep trying the trim and tail adjustments on the one copter that's not DOA.

Powered by Yahoo! Answers

Why does my RC helicopter spin in circles?

mini rc helicopter trim image

Jessica

when i was playing with my RC Helicopter it fell and it couldn't rise anymore it just spins in circles... the module type is Vision SO10 mini 3... pls help!

Answer
In a coaxial copter like yours, the tail rotor serves to pitch the copter to go forwards or backwards. The coaxial blades spin in opposite directions to counter act the spin force that a tail rotor would otherwise handle.

What this means for you is that one set of blades is spinning faster than the other, causing the bird to spin around. If you have a trim adjustment on the throttle stick, you can use it to make one motor spin faster than the other. Or, to balance them out rather.

What is the best remote control airplane to buy under $80?

Sam

I want a good remote control airplane that is not to expensive, but good quality.

Answer
Syma S012 Apache AH-64 Mini 3-Channel Infrared RC Helicopter ---NEW!
No Assembly required, Ready To Fly!Flight Stabilizing System with adjustable trimming control.
Real Helicopter Performance with Stable Hover. Full 3 Channels : Up, Down, Left, Right, Forward and Backward.
An incorporated auto stability system making it easy to fly.
A pre-installed 3 channel proportional wide beam infrared control system that is also tri-band A, B, C.
Recharging takes place via the transmitter. The transmitter has an Alignment Trim, a Charging and Power Indicator, a Left/Right Lever and a Trimmer.
http://www.amazon.com/Apache-3-Channel-Infrared-RC-Helicopter/dp/B001O271YG/?tag=partptl-20
.............

Powered by Yahoo! Answers

my rc mini helicopter is spinning?

mini rc helicopter trim image

Benji

I've adjusted the trim but its still spinning. what should i do?

Answer
your tail rooter is prolly isent spinning fast enough or is spinning to fast

RC Helicopter Help!?

krautpiero

I recently got a RC Helicopter, Bladecx made by E-flight. I watched th video, read the manual, but i still cant figure out why my helocopter always tilts forwards or bac, or left or right. Can someone help me?

Answer
I too have a Blade CX, and I had no idea these things were so hard to fly (without crashing). If there are any nicks in the blades, a slightly bent balance bar or main shaft, or even the battery slightly out of position it will throw the flying characteristics off. There is a procedure for balancing the motors, where you adjust potentiometers on the 3 n 1 unit to get the trims closer to perfect, and it is in the instructions. Don't give up, helicopters are just plain more difficult to fly. Just try to be light and smooth on the sticks and take your time. I raced RC cars, trucks, truggies, minis, etc and the Blade CX was still an entirely new experience for me, and I'm still not an adept pilot, but I am getting better, and so will you.

Powered by Yahoo! Answers